Heavy-gauge vapor barriers, sealed foundation vents, and a dedicated sump discharge line so your Hopkins, MN crawl space stops feeding moisture into the floor joists above it.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
Every crew member is trained specifically on liner installation, seam sealing, and vent encapsulation, not general basement work.
Hopkins, MN crawl space calls get scheduled fast, especially when there's standing water or an active mold smell involved.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
Every Hopkins, MN Crawl Space Encapsulation job starts with an inspection, not a generic package — here's what that typically includes.
Extraction equipment includes submersible pumps sized for tight crawl space access points.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Open foundation vents pull in humid outside air, which is often the real driver of Hopkins, MN crawl space condensation — we seal them as part of encapsulation.
We route discharge lines well away from the foundation so pumped water doesn't just cycle back in.
We also check subfloor insulation for water damage and replace anything compromised before closing the liner.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
We take humidity and moisture readings to establish a baseline before recommending a system.
You'll see square footage, liner grade, vent sealing, and dehumidifier specs broken out in the written estimate.
We re-test humidity after installation to confirm the space is holding at a healthy level before we consider the job done.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— Hopkins Homeowner
"Wood floors upstairs were starting to cup from crawl space humidity. Encapsulation plus a dehumidifier stopped it before we had to replace flooring."
— Hopkins Customer
"Access to our crawl space is tight and awkward, but the crew didn't seem bothered by it at all."
— Hopkins Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Hopkins Customer
A vapor barrier is just the liner on the ground; full encapsulation seals vents, walls, and often adds a dehumidifier for complete moisture control.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
Some jurisdictions have code requirements around vent sealing, which we'll flag during the inspection if relevant.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Spaces with extensive prior water damage or debris may take longer — we'll give you a realistic estimate up front.
We encapsulate crawl spaces throughout Hopkins and the surrounding Hopkins, MN service area, including the zip codes listed below.
Zip codes we serve in Hopkins, MN: 55343 55305
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
